Is your Netgear router acting weird? Can’t you access the Netgear Genie login page using 192.168.1.1? Have you forgotten the routerlogin credentials? If yes, then the only solution you are left with is to reset your Netgear router back to the default factory settings.
Over time, users often face issues with their Netgear routers. Such issues may range from slow internet connectivity to poor WiFi signals. In such a case, it becomes crucial to reset your Netgear router back to the default factory settings.
Before you reset your Netgear router – it is important for you to be aware of the fact that the factory reset process erases all the personalized information and data on your device including username, password, and security settings. In the event that you need routerlogin details of your Netgear device, ensure to have a back up of the data from your end.
Once you’re done with having the back up of the data of your Netgear router, below are the steps you need to follow for resetting your router to default settings. Scroll down a little to read more!
Reset Netgear Router
Here’s how to reset Netgear router. There are 2 easy methods to take your Netgear router back to the factory default values. You can either use hard reset or soft reset method to take your Netgear device back to the default values. Let’s make you familiar with both the processes one-by-one. Keep scrolling down!
How to Soft Reset Netgear Router?
Follow the steps highlighted below in exact given order to factory reset Netgear router:
Step 1: First things first, make sure that the LEDs on your Netgear router are lit. In case, the LED on the device is blinking, wait till it becomes stable.
Step 2: Log in to your Netgear router using 192.168.1.1 default IP.
Step 3: Now, navigate to Netgear Genie setup wizard and locate the Reset option.
Step 4: Click on it, confirm your decision and wait for some time till your Netgear router resets back to the default factory settings.
After you reset your Netgear device, ensure to configure it again to enjoy the lag-free internet in every nook and cranny of your house.
Note: Do not use free/public WiFi to configure your Netgear router.
How to Hard Reset Netgear Router?
To hard reset your Netgear router, do the following:
Step 1: First of all, ensure that your Netgear router is getting steady power supply. Do not use a damaged, loose, or fluctuated wall socket to plug in your Netgear router. Doing so will somehow harm your device.
Step 2: Don’t forget to disconnect your Netgear router from modem and other connected devices (if connected).
Step 3: Now, locate the reset hole on your Netgear router and press it using a pin, oil pin or paper clip.
Step 4: Hold the Netgear router reset hole for some time and release it.
Step 5: The power LED on the device will start blinking and become green and stable shortly.
Fab! In this way, you can hard reset your Netgear router with ease. Now, you can access the Netgear Genie login page using the 192.168.1.1 IP address and configure it again by following the on-screen instructions.
Note: Make sure to reset your Netgear router properly. Bear in mind that a wrongly performed Netgear router reset process may make your device non-working.
The Bottom Line
Just in case, you failed to reset your Netgear router using the hard reset or the soft reset method, without much delay, drop your queries into the comments section. And if the reset methods mentioned in this post proved helpful to you, do share your feedback with us.
Leave a reply
